The Finish Bar
Sample the mood before the metres.
Touch it in your light Measure after the yes Wrap it, own it
Replacement Blades 10 Pack
Ten SK2 high carbon steel blades for sharper, cleaner cuts. When you are wrapping cabinets, drawers, shelves, or furniture, the blade matters as much as the wrap. A dull blade can pull, drag, and leave rough edges. A fresh carbon steel blade gives you more control.
SK2 is a high carbon tool steel commonly used for precision cutting blades. The higher carbon content helps the steel harden well, so the edge can be ground sharper and stay crisp through detailed trimming. For vinyl wrap, that means cleaner corners, smoother edge cuts, and less pressure on the surface underneath.
Use a fresh blade before the final trim, especially around handles, corners, joins, and visible edges. If the blade starts to snag or drag, replace it. That small swap is usually the difference between a DIY edge and a clean finished edge.
Dispose of used blades safely and keep replacements away from children.
Good to know
Questions, answered
How much do I need?
Velven wraps come in two widths, 60 cm and 120 cm. Choosing the width closest to your surface reduces joins, keeps the grain flowing, and makes the job smoother.
Allow a margin of around 3 to 5 cm on each side for trimming and clean, confident edges. For larger projects, a little more overhang helps.
Not sure how much to order? Work out how much you need or contact us with your measurements and we will help.
How will it look in my space?
Every space carries its own light, rhythm, and character. We capture each wrap colour as truly as we can, but every screen shows it a little differently.
For the most honest sense of a finish, order an A4 sample and place it where it will live. Notice how it shifts through the day, from the quiet light of morning to the softness of evening. It is the simplest way to see how the surface will sit in your room.
Where can I use this?
Velven sticks to most smooth, sealed surfaces. Cabinetry, furniture, doors, benchtops, splashbacks, shelves, and panels all work. Kitchens, a quiet corner, an open living space, it gives a tired surface depth and texture again.
Change the one surface you look at every day, and the whole room feels different. That is the idea.
How easy is it to install?
Velven was made with DIYers in mind. The backing lets you lift and reposition as you go, so you can refine each step without worry.
Every wrap strikes a balance, soft enough to bend around curves and edges, yet strong enough to resist tearing or warping. No special skills needed, just a steady hand and a little patience.
Want the full walkthrough? Read our how to wrap guide.
Can I remove it later?
Yes. Velven lifts cleanly from most sound, sealed surfaces. Warm it gently with a hairdryer and peel slowly at a low angle. If the surface underneath is delicate or the paint is old, test a small hidden area first, since weak paint can lift with any adhesive.
Renters, see the renter friendly guide for the bond safe way to do it.
Is it sustainable?
Most kitchen joinery in Australia is made from MDF or particle board, materials engineered from wood fibres bonded with resins. They are strong and versatile, but hard to recycle.
At the end of their life most are sent to landfill, because the resin stops the fibres being separated and reused, and local recycling options are limited.
By resurfacing what you already have instead of replacing it, Velven helps extend the life of these materials and keeps usable joinery out of landfill.
What tools do I need?
You can start with tools you already have at home, like scissors, a sharp knife, and a hairdryer. For the best result, use a sharp snap off blade, a squeegee or felt edged applicator, a steel ruler, and a hairdryer or heat gun on low to soften the edges as you work.
How do I clean it?
Wipe with a soft cloth or sponge using mild soap and water. Avoid harsh abrasives and solvents so the finish keeps looking its best.